Reflectivity and the Westside Cooling Bills — Myths and Facts
What a real inspection covers on a roof coating in West LA, and what usually gets skipped.
A roof inspection is only as good as what gets looked at, and a lot of what gets called an inspection is a walk round the garden with a phone camera. This is what a real one covers on a roof coating in the Westside.
What actually matters
A coating is a renewal of a roof that still works, not a repair of one that does not. Applied to the right substrate it can add years for a fraction of a tear-off; applied to the wrong one it seals a problem inside. An inspection that does not account for that is looking at the wrong layer.
The detail that is usually left out
An inspection is only as good as what gets looked at, and photographs of specific defects are what let you get a second opinion without a second visit. Wet film thickness is the number that matters. It is measured during application with a simple gauge, and it is the only way to know the roof is getting the millage that was quoted rather than a thinner coat spread further. Anything under half an hour on an average house has skipped something.
What is specific to the Westside
The marine layer decides most of what happens here. Roofs sit damp until late morning for a good part of the year, dry out in the afternoon, and do it again the next day. That cycle is gentle on the material and hard on anything organic: north-facing slopes hold moss and algae, and shaded valleys stay wet long enough to rot a felt underlayment that would have been fine two miles inland. There is a wide spread of stock, from 1920s Spanish with original clay through to flat-roofed modern rebuilds, and the two need completely different attention.
The full inspection list
- Substrate moisture, established before anything is quoted
- Adhesion, confirmed by test patch rather than assumed
- Surface contamination, chalking and existing coating compatibility
- Seam and penetration reinforcement requirements across the roof
- Ponding areas, which need drainage correction before coating
- Wet film thickness recorded during application
- Manufacturer specification for the substrate actually present
Common questions
How long should an inspection take?
Long enough to get on the roof and into the attic. Anything under half an hour on an average house has skipped something.
Should I expect photographs?
Yes, and of the specific defects rather than general views. Photographs are what let you get a second opinion without a second visit.
The honest summary
A coating over a sound, dry, properly prepared roof is one of the best-value things available. Over wet insulation it is money spent trapping the problem where nobody can see it. In the Westside the thing to watch is north slopes, shaded valleys and anywhere the morning damp does not clear by noon.
Free inspection, drone photography where access is difficult, and a written estimate with deck repair priced per sheet. No obligation.